4 Channel Power over Ethernet Midspan Injector Single Sided

Power over Ethernet uses your LAN to send power via the network cable to whatever device you have connected at the other end, saving you the hassle of plugging the device in to both the network and to power PoE lets you centralise your power supplies

Home brew PoE typically involves trimming back part of a LAN cable, separating out the relevant pairs of cable, cutting them, and soldering on a power socket so you can connect a plug pack That works fine, but it’s ugly, fiddly, and takes time Our 4 Channel Power over Ethernet Midspan Injector is the solution Just unplug your LAN cables from your switch, plug them into the device ports on the injector, run short LAN cables from your switch to the switch ports on the injector, and plug in whatever wall wart power supply you have handy Done No soldering required

Note: this module does not provide proper, standards compliant 802 3af PoE support But it’s a whole lot cheaper, and works with just about any home brew PoE system

Works great with our various Ethernet products with PoE support, including the , , and

Features

• 2 1mm power jack suits many common wall wart plug pack supplies Same connector as used on Arduino
• Input voltage 7V to 48Vdc
• Output voltage is whatever you feed into it
• Power on indicator LED
• Four channels: suitable for powering up to four devices

Note: There is no power supply included because your requirements will depend on your local mains voltage depending on where you are in the world This injector works with any wall wart plug pack that provides an appropriate output voltage and has a 2 1mm DC power connection